Inorganic Coagulant KP35AC + Cationic Flocculant C6660 for Organic Waste Treatment

Inorganic Coagulant KP35AC + Cationic Flocculant C6660 for Organic Wastewater Treatment

1. Use Inorganic Coagulant KP35AC in the initial process before adding the flocculant to neutralize colloidal particle charges (coagulation) so that they can clump.

2. Next, use Cationic Flocculant C6660 to help form flocs (aggregation of fine particles into larger ones) after the coagulation process.

SPECIFICATION KP35AC
Appearance: Yellowish
pH: 2.0 – 4.0
Specific gravity: 1.20 – 1.25
Solubility: Soluble in water

DOSAGE AND HOW TO USE KP35AC

1. General dosage: 5–10 ppm (5–10 mg per liter of water)

2. Dosage depends on water condition, jar test is recommended for optimal results

3. Used directly without dilution, simply mix into water with stirring

SPECIFICATION C6660
Appearance: White crystalline powder
Relative density water (=1): 1.302
Solubility: Soluble in water

DOSAGE AND HOW TO USE C6660

1. Dissolve this powder with clean water until it becomes a dilute solution (between 0.1% – 0.5%). Example: 1 gram powder + 1 liter water = 0.1%

2. Stir continuously with a mixer or stirrer (medium speed) until fully dissolved

3. Use the solution immediately, maximum 24 hours

4. Dosage depends on requirements:
   Wastewater clarification: 0.5 – 50 ppm (0.5–50 mg per liter of water)
   Sludge dewatering: 0.2 – 7 kg per ton of sludge

ALSO AVAILABLE: Wastewater Treatment Plant (WWTP) Construction and Clean Water Treatment (Free survey visit JABODETABEK)